How To Repair A Gravel Driveway Mooroolbark

Get A Quote – Andrew : 0411 738 098



No matter how hard you work at it, repairing a gravel driveway is simply a fact of life. Potholes, washboards, gravel depletion, erosion. Over time, some or all of those problems will be yours to deal with. So here are some tips for dealing with these problems the right way.

Getting started.
Repairing a gravel driveway starts with getting the driveway surface as close to smooth and even as you can. If you have erosion, potholes, etc., you should use a box blade with scarifiers or land plane with scarifiers to break up the overall surface to the required depth. With potholes, you really need to churn the driveway down to just below the bottom of the pothole, but not into the driveway’s foundation – base layer .

Start by setting the desired depth. A couple inches deep will often suffice. Again, avoid digging into the driveway’s foundation. If you churn up anything half the size of your fist or larger, you’ve gone too deep.

Use the box blade or land plane to work over the entire surface of the driveway.

At this point, you’ll need to decide what size gravel you might need to apply. If your drive is soft and potentially muddy, you should consider putting down a layer of 1½-2½” (3.8-6.4 cm) crushed gravel. This will produce a good, stable layer that would provide good drainage, which will help prevent erosion. You might then top this with a good layer of ¾-inch (12 cm) minus gravel. This means the gravel will include everything from ¾-inch pieces all the way down to fines, or powder. This product will compact well, so you can create a firm, smooth surface.

Smooth things out.
Now, using a rear blade set up perpendicular to your tractor and in its reversed position, smooth the drive’s entire new surface, allowing the blade to float along the ground. You should now have a good, firm surface to work with.

You could also use a land plane instead of a rear blade to accomplish the same thing. When you’re on site and ready to work, with the land plane on the ground, set your 3-point in “float” position. Since the 3-point doesn’t exert any down pressure, your land plane will now float along the surface of the ground.

Beginning in the center of your drive, run the land plane over the surface. Gravel and other material will begin to accumulate in the interior of the land plane. As it fills, the gravel will begin to spread out evenly over the surface of the drive. Make several passes until you’ve covered the entire drive from edge to edge and created a smooth, even surface. Repairing a gravel driveway takes a bit of time, but if you do it right, keeping it in good shape will be a lot easier down the road.

And remember, always read the Operator’s Manual before operating any piece of equipment and follow all operating and safety instructions.

This Information is shared to you from


Please do not hesitate in calling us if you need a quote for any gravel driveway repairs and maintenance – Andrew : 0411 738 098